MC-320/21-2
18
English
Clock/Timer
Setting the clock
1 In standby, press and hold CLOCK SET / .
➜ The clock digits for the hours flash.
2 Press VOLUME –/+ to set the hours.
3 Press CLOCK SET / again.
➜ The clock digits for the minutes flash.
4 Press VOLUME –/+ to set the minutes.
5 Press CLOCK SET / to confirm the time.
Note:
– The backlight for clock display is dim in standby.
Setting the timer
● The system can be used as an alarm clock,
whereby the CD, TUNER or TAPE is switched on
at a set time. The clock time needs to be set first
before the timer can be used.
● You can also use it to record a favourite tuner
programme at a set period (see “Recording
timer”)
● During setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
1 In standby mode, press TIMER SET / on the
system for more than 3 seconds.
2 Press SOURCE or VOLUME –/+ to select
sound source.
➜ Display sequence shows CD, TUNER, TAPE or
REC TUN.
3 Press TIMER SET / to confirm your desired
mode.
➜ Display sequence scrolls SET ON TIME and
flashes. The clock digits for the hours flash.
4 Press VOLUME –/+ to set the hours.
5 Press TIMER SET / again.
➜ The clock digits for the minutes flash.
6 Press VOLUME –/+ to set the minutes.
7 Press TIMER SET / to confirm the time.
➜ The timer is now set and activated.
Activating and deactivating
TIMER
● In standby or during playback, press
TIMER ON / OFF on the remote control
once.
➜ Display shows if activated, and disappears
if deactivated.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time.
● Press SLEEP on the remote control once or
more.
➜ Display shows SLEEP and one of the sleep
time options in sequence: 90, 80, 70, 60,...,
20,10, OFF, 90. if you have selected a time.
Once SLEEP is activated, SLEEP is display.
● To deactivate, press SLEEP
on the remote control once or
more until OFF is shown, or
press STANDBY ON on the
system or remote control.
➜ OFF is displayed.
To Next Page
Loading...
