3-23-2
Dismantling of the Amplify PCB
1) Loosen 2 screws "K" as shown in Figure 2.
2) Loosen 1screw "L" on the heatsink as shown in Figure 10.
3) Unplug the connectors "M" that connect amplify board and power board as shown in Figure 1
1.
4) Shift the amplify board together with back panel from the bottom cover.
Figure 10
Figure 14
Figure 11
Figure 12
N
L
O
M
Dismantling of the Scart PCB
1) Loosen 2 screws "Q" as shown in Figure 14.
2) Separate the scart board from the back panel.
Dismantling of the Tuner PCB
1) Loosen 2 screws "P" as shown in Figure 13.
2) Separate the tuner module from the back panel.
5) Loosen 5 screws "N" on the back panel as shown in Figure
12 from the back panel.
6) Loosen 3 screws "O" on the heatsink as shown in Figure
10. Remove the heatsink from the amplify board.
P
Figure 13
Q
Dismantling of the Power PCB
1) Loosen 4 screws "R" as shown in Figure 15.
2) Remove the cables connect to power board.
Dismantling of the Transformer
1) Loosen 4 screws "S" as shown in Figure 16.
2) Shift the transformer from the bracket.
R
Figure 15
S
Figure 16
To Next Page
Loading...
