Philips MCD106 - Getting Started; Step 1: Using the Remote Control; Step 2: Setting up the TV

2 - 12 - 1
System , Region Code , etc. Setting Produre
1) System Reset
(1) System reset
a) Press “setup” button on R/C, TV will show the “setup” menu.
b) Select the menu using the q on R/C.
c) Selcet default to restore system setting.
remark: But can’t restore region code default setting.
(2) Region code reset
a) Open CD Door.
b) Press “stop” button on RC, then press “0000” TV Display
”DEFAULT”.
c) The system will switch to standby when finished,and region code
will to be default setting.
2) Region Code Change
a) Press “5168” on R/C in open mode.
b) Use "q” “p” on R/C to selece desirde region code in custorner
page.
c) Pess “OK” to confirn:
1 USA
2 EU
3 AP
4 Australia, NZ, Latam
5 Russia,INDIA
6 CHINA
3) Password Change
a) Press “setup“ button on R/C,TV shows the “setup“ menu.
b) Press "u” to select “password”, then press “u/OK”.
* 0000 is default password supplied.
4) Check on the Sofeware Version
a) Open the CD door.
b) Press “stop 159” button on R/C.
c) TV will show the version on screen.
5) Upgrading new sofeware
a) Open the CD door,then insert the CD-R program disc.
b) Close the CD door.
c) TV will show the upgrade prompt menu, and the system will auto
upgrading, the system will switch to standby when  nish upgrading.
* the latest upgraded is in version VER 070602.
CAUTION !
This information is con dencial and may not be
distributed. Only a quali ed service person should
reprogram the Region Code.