Philips MCM103/93 - Auto Install Radio Stations; Set Clock; Turn on; Switch to Standby

12
5 Press CLOCK/DISPLAYWRFRQÀUP
The minute digits are displayed and »
begin to blink.
6 Press / to set the minute.
7 Press CLOCK/DISPLAYWRFRQÀUP
Tip
To view the clock during play, press  CLOCK/
DISPLAY repeatedly until the clock is
displayed.
Turn on
1
Press POWER.
The unit switches to the last selected »
source.
Switch to standby
1 Press POWER to switch the unit to
standby mode.
The backlight on the display panel is »
dimmed.
The clock (if set) appears on the »
display panel.
Note
If you are not going to use the remote control 
for a long time, remove the batteries.
Do not use old and new or different types of 
batteries in combination.
Batteries contain chemical substances, so they 
should be disposed of properly.
Auto install radio stations
When you connect the unit to the power
VXSSO\IRUWKHÀUVWWLPHRUQRUDGLRVWDWLRQLV
stored in this unit, Plug and Play is activated to
store all available radio stations automatically.
1 Connect the unit to the power supply.
[AUTO INSTALL - PLEASE PRESS »
PLAY, STOP CANCEL] (press the
PLAY button to auto install; to cancel,
press
) displays.
2 Press on the main unit to start
installation.
[AUTO] displays.»
The unit automatically store radio »
VWDWLRQVZLWKVXIÀFLHQWVLJQDOVWUHQJWK
When all the available radio stations »
DUHVWRUHGWKHÀUVWSUHVHWUDGLRVWDWLRQ
is broadcast automatically.
Set clock
1
Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
The 12 hour or 24 hour format is »
displayed.
2 Press PROG repeatedly to select 12 hour
or 24 hour format.
3 Press CLOCK/DISPLAYWRFRQÀUP
The hour digits are displayed and begin »
to blink.
4 Press / to set the hour.
EN