Prepare
Setting the clock
2
3
4
5
6
In the standby mode, press and hold DISPLAY/CLOCK on the remote control
➜ 24 HR or 12 HR appears for the initial clock setting. To select 12-hour clock or
24-hour clock,
a.
Press VOL +/- once or more
b. Press
DISPLAY/CLOCK to confirm
➜ The hours digits start flashing
Hold down or press
VOL +/- repeatedly to set the hours
Press DISPLAY/CLOCK to confirm
Hold down or press
VOL +/- repeatedly to set the minutes
Press DISPLAY/CLOCK to confirm
Enjoy
1
2
3
4
5
Playing discs
With this system, you can play all pre-recorded audio CDs (CDDA), all finalized audio CD-Rs
and CD-RWs, MP3/WMA-CDs (CD-Rs/CD-RWs with MP3/WMA files)
Press SOURCE once or more to select CD (or CD on the remote control)
Press CD OPEN•CLOSEç to open the CD compartment
Insert a disc with the printed side facing up. Press CD OPEN•CLOSEç again
to close the compartment
Press ÉÅ to start playback
To stop playback, press STOPÇ
Notes for remote control:
– First, select the source you wish to
control by pressing one of the source
select keys on the remote control (DISC
or TUNER, for example).
– Then select the desired function
( 2;,
4
,
¢
for example).
IMPORTANT!
– Remove the protective plastic
tab before using the remote
control
1
Press and hold STANDBY-ON/ ECO POWER y to switch the set to Standby mode
➜ The display shows the set time
➜ -- --:-- -- flashes by default if you have not set the clock
Helpful hints:
- To set the clock automatically by using a time signal which is broadcast
together with the RDS signal, see the User Manual, RDS: Automatic clock setting via RDS.
Remove the plastic protective sheet
MCM277 QSG_-22-Eng 2007.12.27, 14:223
To Next Page
Loading...
