Figure 1
DISMANTLING INSTRUCTIONS
2-1 2-1
Dismantling of the 5DTC Module
1) Loosen 4 screws and remove the Cover Top (pos 255) by
sliding it out towards the rear before lifting up.
- 2 screws on the rear
- 1 screw each on the left & right side
2) Loosen 3 screws each to remove the Panel Left (pos 253)
and Panel Right (pos 254). The Panels are remove by
sliding it towards the rear and outwards.
- 1 screw on the side
- 2 screws on the rear
3) Take a paper clip or any stiff wire diameter of 1mm-1.5mm.
Place the set in position and insert the paper clip or stiff
wire as shown in Figure 1.
1) Remove 2 screws B (pos 282) as shown in Figure 4 from
the bottom of the Cabinet Front (pos 101).
2) Release the fixation of the Combi Board (pos 1102-1001)
to Bracket Combi (pos 252) by releasing the 2 catches C1
(see Figure 5) and pulling the Combi Board outwards as
shown in Figure 6.
3) Uncatch 2 catches C2 (see Figure 5) on the left & right
sides of the Cabinet Front (pos 101) and slides the Front
Panel assembly out towards the front.
Detaching the Front Panel assembly from the Bottom/Rear assembly
4) To remove the Cover CD Orn (pos 111), you have to feel
and give a push in the correct direction (see Figure 1) and
correct position (see Figure 2) to release the catch of the
Cover CD Orn before removing it out.
5) Loosen 4 screws A (see Figure 3 and Figure 9) to remove
the 5DTC Module (pos 1103).
- 2 screws on the front
- 2 screws on the rear
Note : For information on the 'Emergency opening of the
trays' of the 5DTC Module, refer to Chapter 10
(Page 10-7).
Figure 2
Figure 5
Figure 4
Figure 3
Figure 6
To Next Page
Loading...
