Service position A
Service position B
Service position C
2-3 2-3
DISMANTLING INSTRUCTIONS
Repair Hints & Service Positions
1) During repair it is possible to disconnect the ECO6 Tuner
board and/or 5DTC Module completely unless the fault is
suspected to be in that area. This will not affect the
performance of the rest of the set.
Note: The flex cables are very fragile, care should be taken
not to damage them during repair. After repair, be
very sure that the flex cables are inserted properly
into the flex sockets before encasing, otherwise faults
may occurs.
To Next Page
Loading...
