Philips MG1100 - Shaving with the precision shaving head; Cleaning

Shaving with the precision shaving head
1 Put the precision shaving head on the appliance (see section
‘Attaching and detaching the attachments’ in chapter
‘Preparing for use’).
2 Place the precision shaving head at a 90° angle onto the skin and
move the appliance slowly and smoothly against the direction of hair
growth.
3 Make sure that the whole shaving head is in contact with the skin.
As hairs grow in different directions, move the appliance in different
directions (upwards, downwards and sideways).
4 Switch off the appliance.
Cleaning
Clean the appliance immediately after use and when a lot of hair or dirt
has accumulated on the cutting elements.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the cutting elements.
1 Switch off the appliance.
2 Rinse the precision trimming head, the trimming combs and the
precision shaving head with lukewarm water.
Note: You can also use the cleaning brush to clean the precision trimming head,
the trimming combs and the precision shaving head.
3 Let all parts dry completely before you use the appliance again.
ENGLISH 9