Trimming with precision trimming head with precision
trimming comb
1 Put the precision trimming head on the appliance (see section
‘Attaching and detaching the attachments’ in chapter
‘Preparing for use’).
2 Choose the short, medium or long trimming comb, depending on the
desired hair length. The indications ‘S’, ‘M’ and ‘L’ are on the combs.
- Short trimming comb (S): 1mm
- Medium trimming comb (M): 3mm
- Long trimming comb (L): 5mm
Tip: We advise you to start trimming with the long comb.
3 Slide the trimming comb onto the front of the precision trimming
head and push it onto the back until it locks into place (‘click’).
4 Switch on the appliance.
5 Move the appliance slowly and with light pressure against the
direction of hair growth.
Note: To make trimming easier, stretch the skin with your free hand during
trimming.
Note: Make sure that the at part of the comb always touches the skin to
obtain an even result.
Note: Do not press the appliance with the comb onto the skin too hard.
This may cause the appliance to trim the hairs shorter than the length
indicated on the comb.
Note: In areas where the hair grows in different directions, move the appliance
upwards, downwards and sideways.
6 Regularly remove cut hairs from the comb. If a lot of hairs have
accumulated in the comb, detach the comb from the appliance and
blow and/or shake the hairs out of it.
7 Switch off the appliance.
M
M
ENGLISH8
To Next Page
Loading...
