-
Always check shaving heads (caps and cutters) before using
the product. Do not use the product if cutters or caps are
damaged, as injury may occur.
-
Always attach power cord to product first, then to power
outlet. To disconnect, turn your shaver of before removing
the power cord from the power outlet.
-
Plug power cord directly into power outlet. Do not use an
extension cord.
-
Unplug power cord before plugging in or unplugging the
product.
-
Only use the power cord and other accessories supplied with
the product.
-
Do not attempt to open the product to remove or replace the
built-in rechargeable battery.
-
The batteries used in this product may present a fire or
chemical burn hazard if mistreated. Do not disassemble, heat
above 100°C (212°F) or incinerate.
IMPORTANT: The power plug contains a transformer. Do not
cut off the power plug to replace it with another plug as this will
cause a hazardous condition.
SAVE THESE
INSTRUCTIONS
General description (Fig. 1)
1 Protection cap
2 Shaving unit
3 Shaving unit release button
4 On/off button
5 Shaver head replacement indicator
6 Charging light and 'battery low' indicator
7 Pop-up trimmer
8
To Next Page
Loading...
