ENGLISH
C 6 Clean the inside and outside of the comb
by rinsing under hot water.
For optimum performance, shaver cutters and
combs should be cleaned in a degreasing liquid
(e.g. alcohol) and lubricated with one drop of
mineral oil (in the center of the head). This helps
prevent wear of the shaving heads.
C 7 Replace the set back into the shaving unit.
Make sure that the projections of the shaving
head fit exactly into the recesses.
8 Repeat the process for the other two sets
of cutters and combs.
C 9 Put the retaining frame back into the
shaving unit.
C 10 Reattach the shaving unit and shake excess
water off the shaver.
NOTE: If the shaving unit does not close smoothly,
make sure you inserted the shaving heads
properly and that the retaining frame is locked.
18
1
2
To Next Page
Loading...
