18
» The CHR indicator turns on (red). It takes about 7 hours to fully
charge the battery.
» When the battery is fully charged, the CHR indicator turns off.
Install remote control battery
Caution
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Batteries contain chemical substances, they should be disposed of properly.
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
*+;
1 Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
3 Close the battery compartment.
EN
not supplied
PD9000_37_UM_V1.0.indb 18 2012/1/5 16:23:12
To Next Page
Loading...
