Philips PD9000 - Remote Control Battery Installation

18
2 Connect the supplied AC adaptor to the player and to the AC outlet.
» The CHR indicator turns on (red). It takes about 7 hours to
fully charge the battery.
» When the battery is fully charged, the CHR indicator turns
off.
Install remote control battery
Caution
• Riskofexplosion!Keepbatteriesawayfromheat,sunshineorre.Neverdiscardbatteriesinre.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
• Batteries contain chemical substances, they should be disposed of properly.
• Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
For rst-time use:
1 Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
EN