B to switch to standby
S for pause (
VCR, DVD, CD)
® for record,
Ò for rewind (
VCR, CD);
search down (
DVD, AMP)
‡ for stop
π for play
† for fast forward (
VCR, CD);
search up (
DVD/AMP)
æ to select your choice of
subtitle language (
DVD);
RDS news/TA (
AMP);
to shuffle play (
CD)
b to select a dvd title;
RDS display (
AMP);
info on screen (
CD)
i display information
MENU to switch the menu on or off
-P+ for chapter, channel, track
selection
0 to 9 digit entry
0 tape index (
VCR),
select a
DVD chapter,
select a frequency (
AMP)
U VCR timer
Q surround on/off (
AMP, CD)
cursor up/down
to select the next or the
previous disc (
CD)
cursor left/right
to select the previous or
following track (
CD)
search up/down (
AMP)
Record with your recorder with EasyLink
In TV mode, it is possible to start a direct recording of the programme which is
being displayed on the TV screen. Continue to press the ® record key on the
remote control for more than 2 seconds.
Note:
Switching programme numbers on your TV does not disturb recording !
When recording a programme from a peripheral connected to
EXT. 1, EXT. 3 or SIDE, you
can not select another TV programme on the screen.
This system remote control operates the following Philips equipment:TV,VCR,
DVD, SAT (RC5),AMP (+TUNER), CD;
Press the
Select key to operate any of the equipment indicated in the display.
Another device can be selected by pressing Select repeatedly within 2 seconds.The
led will blink slowly to indicate the device.
Press one of the keys on the remote control to operate the peripheral equipment.
To r eturn to TV mode press
Select while the led is blinking.
When no action is taken within 60 seconds, the remote goes back to TV mode.
Note:When the
Select key is pressed and held for more than 2 seconds, the RC5/RC6
system select command is transmitted.
Additionally the DVD, SAT and CD indicator can be programmed to operate the
DVD-R, SAT (RC6), CD-R instead.
& Press the Select key repeatedly until no LED is lit.
é To program DVD-R,press the OK key + digit 2.
To program
SAT (RC6),press the OK key + digit 4.
To program CD-R,press the OK key + digit 6.
From now on, when the corresponding (
DVD, SAT, CD) indicator is selected,
the remote control will operate your DVD-R, SAT (RC6) or CD-R.
Note:To return to the modes programmed in the factory, either remove the batteries for a
few minutes, or press the
OK key + digit 1 (DVD mode); or + digit 3 (SAT-RC5) or +
digit 5 (CD mode).
To Next Page
Loading...
