5Getting Started
2 Getting Started
2.1 Prepare
To insert the batteries in the SRU8008:
1 Press the latch down and lift the cover up.
2 Place the three LR6 AA type alkaline batteries into the battery
compartment, as shown.
3 Position the cover and press firmly until you hear a click.
The SRU8008 displays the Philips logo for
3 seconds and continues with the Installation
Wizard to guide you through the installation.
When the batteries are almost empty, the Battery Low icon blinks.
This indicates a critical battery level. You can still operate the SRU8008
control for a short period.
Replace the batteries with new LR6 AA type alkaline batteries and
follow the local regulations for disposal of the empty batteries.
D Note
If the Battery Low icon blinks, you are not able to enter the
Setup menu anymore.
3
2
1
ENGLISH
1 2 3
Installation wizard –
Language selection
To Next Page
Loading...
