Philips Professional HFL6114U/12 Series - Page 55

- 54 -
o
Navigate to the [
USB break
-
in
] menu
o You can enable USB break-in using [On] or
disable using [Off]
Note: [USB break-in] is only accessible if
[Enable Sources][USB Media Brower] is
checked
o
Navigate to the [
USB Auto Play
] menu
o You will see below items:
o [Off]: From the moment a USB device
is connected to the TV, no files will be
played automatically
o [On]: From the moment a USB device is
connected to the TV, all playable files
in the root from your USB device will
automatically be played in a loop
o
Navigate to the [
HDMI Settings
] menu
o You will see below items:
o [HDMI Plug-in/out]: Disable the
HDMI plug-in detection to switch to
the HDMI source when an HDMI
device is connected to the TV using
[Off] or enable via [On]
o [Fallback on HDMI Break-out]: If
HDMI Plug-in/out is enabled then the
TV will follow this setting when the
HDMI connection is broken and go
back to the [SwitchOnSettings] or go
back to the [Previous Application]
o
Navigate to the [
Easylink
] menu
o You will see below items:
o [Easylink]: Disable all HDMI CEC
functionality via [Off] or enable via
[On]
o [EasyLink Break-in]: TV shall disable
auto tuning/switching to the
connected HDMI CEC enabled source
via [Off] or enable via [On] when
device is plugged or switched on
o [EasyLink Remote Control]: The keys
from your TV RC will not be
forwarded via CEC when [Off] or will
be forwarded when [On]
o [Easylink Application]: When [On],
then TV shall forward the “Menu” key
to the source if the device is HDMI
CEC enabled and supports RC pass
thru