10
Problem Cause Solution
Water leaks from the
soleplate.
Steam condenses into water in the
hose when you use steam for the
long time.
This is normal. Hold the iron away
from the garment and press the
steam trigger. Wait until steam
instead of water comes out of the
soleplate.
The ironing board cover
becomes wet, or there
are water droplets on the
Your board cover is not designed to
cope with the high steam rate.
Use a layer of felt material in the
board cover to prevent water
droplets.
The surface under the base
of the appliance becomes
wet, or steam and/or
water comes out from
under the EASY DECALC
knob.
The EASY DECALC knob is not
tightened properly.
hours for it to cool down. Unscrew
and reattach the knob to make sure it
is tightened.
The rubber sealing ring of the EASY
DECALC knob is worn.
Contact an authorized Philips service
center for a new EASY DECALC knob.
The iron does not heat up
and the amber DECALC
The appliance reminds you to
perform the descaling procedure.
one month of use.
Perform the descaling procedure,
following the instructions in section
‘Descaling the appliance’.
Warranty and support
If you need information or support, please visit www.philips.com/support or read the international
English
9 / 144 8 / 142 9 / 144
To Next Page
Loading...
