Complete in-depth Geometry
To activate the Service Alignment Mode, enter 0-6-2-5-9-6-(Status or Index) using the Remote Control.
Press Status or Index toggle to the Customer menu. Select an active channel. Pressing the Status or
Index button will bring up the SAM mode.
1. Apply a Crosshatch pattern to the set and select that input.
2. Defeat Convergence by shorting the two pins of connector 1005 on the SSM.
3. Press the Cursor-down key on the remote and select Geometry with the Right cursor key.
4. Adjust the Screen Geometry as necessary.
The following are default values:
VER.AMPL 30
VER.SLOPE 34
SERV.BLK OFF
HOR.SHIFT 32
HOR.BOW 20
HOR.PARALLEL 31
EW.WIDTH 22
EW.PARA 21
EW.TRAP 19
EW.UCORN 6
EW.LCORN 0
H60.WIDTH 2
H60.PARA 0
H60.SHIFT 7
V60.AMPL 0
VER.SCOR 18
VER.SHIFT 35
VER.ZOOM 32
VER.SCROLL 32
To save changes, use the Menu button on the Remote to back out to the main menu. Then turn the set
off using the power button on the Remote or the front of the set. This will save any changes made.
To Next Page
Loading...
