Philips S7310 - Removing Old Shaving Heads; Installing New Shaving Heads; Securing Retaining Rings; Caution During Reassembly

4 Remove the shaving heads from the shaving
head holder and throw them away.
5 Place new shaving heads in the holder.
Note: Make sure the notches on both sides of the
shaving heads t exactly onto the projections in the
shaving-head holder.
6 Place the retaining rings back onto the shaving
heads (1) and turn them clockwise (2).
Note: Hold the shaving head holder in your hand
when you reinsert the shaving heads and reattach the
retaining rings. Do not place the shaving head holder
on a surface when you do this, as this may cause
damage.
7 Reattach the shaving head holder to the
bottom part of the shaving unit.
8 To reset the shaver, press and hold the on/off
button for approx. 7 seconds.
ENGLISH18