Philips S9731/33 - Page 34

6 Place the retaining ring holder on the retaining
ring (1), place it on the shaving head (2) and
turn it clockwise (3) to reattach the retaining
ring.
Repeat this process for the other retaining rings.
7 Reattach the shaving head holder to the
bottom part of the shaving unit.
8 To reset the shaver, press and hold the on/off
button for approx. 7 seconds. Wait until you
hear two beeps.
Replacing the cleansing brush attachment
The brush head should be replaced every 3 months
or earlier if the laments are deformed or damaged.
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service. or go to your
Philips dealer. You can also contact the Philips
Consumer Care Centre in your country (see the
worldwide guarantee leaet for contact details).
The following parts are available:
- HQ8505 adapter
- SH90 Philips shaving heads
- HQ110 Philips Shaving Head Cleaning Spray
- RQ111 Philips beard styler attachment
- RQ585 Philips cleansing brush attachment
- RQ560/RQ563 Philips cleansing brush heads
- JC301/JC302/JC303/JC304/JC305 cleaning
cartridge
34 ENGLISH