Problem Possible cause Solution
To clean the shaving heads
thoroughly, remove the
shaving heads from the
shaving head holder one
by one (see
'Replacement'). Then
separate the cutter from its
guard and rinse each
matching set under the tap.
After rinsing, place the
cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder (see
'Replacement').
I replaced the
shaving heads,
but the display
still shows the
replacement
reminder.
You have not reset
the appliance.
Reset the appliance by
pressing the on/off button
for approx. 7 seconds (see
'Replacing the shaving
heads').
A shaving unit
symbol has
suddenly
appeared on the
display.
This symbol
reminds you to
replace the shaving
heads.
Replace the shaving heads
(see 'Replacement').
An exclamation
mark has
suddenly
appeared on the
display while the
appliance is
charging.
The appliance is
overheated.
Disconnect the appliance
from the wall socket for
approx. 10 minutes.
36
English
To Next Page
Loading...
