Philips SBCHC8300/05 - Audio Connections

Headphone battery
replacement (figure 3)
IMPORTANT
Use only rechargeable LR03/AAA
NiMH batteries (preferably Philips).
Do not use NiCd batteries or
alkaline batteries as these may damage
your FM wireless system!
1 Open the headphone’s battery
compartment.
2 Take out the batteries and dispose of them
properly.
3 Insert new batteries. Only use LR03/AAA
NiMH batteries (preferably Philips).
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Close the battery compartment.
IMPORTANT
Before using the FM headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
Connecting the FM transmitter to a
headphone output of an audio
source (figure 4)
1 Connect the 3.5mm stereo plug of the
stereo audio cable to the headphone
output of an audio source, such as TV, HiFi
or PC.
– In case your audio source has a 6.3mm
headphone output, use the supplied
3.5mm to 6.3 mm stereo adapter plug.
2 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
3 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
4 To tune, turn the tuning wheel until the
signal is at its clearest and the tuning
indicator will light up.
5 Adjust the volume to the desired level with
the headphone volume control.
Basic operation
When the FM transmitter is connected to a
headphone output of an audio source.
1 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
2 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
3 To tune, turn the tuning wheel until the
signal is at its clearest and the tuning
indicator will light up.
4 Adjust the volume to the desired level with
the headphone volume control.
Installation Audio Connections
7
English
XP SBC HC 8300/00-1 12-06-2001 11:53 Pagina 7