Philips SBCSC205 - Troubleshooting Common Issues; Unit Not Warming Up; Technical Specifications

10
PROBLEM SOLVING
Solution
Empty some water from the inner
container.
Empty some water from the inner
container.
Leave bottle in container for a few seconds
after the indicator light has switched off,
or increase the adjustment setting.
Lower the adjustment setting.
Remove bottle when indicator lamp goes
out.
Stir the contents from time to time while
heating. Check that the click-step control
knob is in the “ ” position.
Wait 15 minutes between consecutive uses
to allow the safety cut-out to reset.
This is normal (it may turn on or off while
heating).
Shield indicator from ambient light to
improve visibility.
Hard water deposits are normal and may
increase if your water is very hard; remove
the deposits periodically with white
vinegar.
Problem
Overflow of water.
Bottle floats.
Temperature too low.
Temperature too high.
The jar has not heated
correctly.
Unit does not warm up.
Indicator light switches on
and off while keeping
warm.
Indicator light does not
seem to light.
The bottom of the tank is
spotted.
19
SPÉCIFICATIONS TECHNIQUES
Modèle SBC SC205
Alimentation : 110-120V CC
Consommation électrique : 100 Watts
Température ambiante opérationnelle: entre 44.6°F (+7ºC) et 98.6°F
(+37ºC)
Protection : système de chauffage à contrôle
PTC de la température
Conformité norme de sécurité : conforme à UL 1026
Modèle SBC SC215
Alimentation (secteur) : 110-120V CC
Consommation électrique (secteur) : 90 Watts
Alimentation (batterie de voiture) : 12V CC
Consommation électrique (batterie de voiture): 80 Watts
Température ambiante opérationnelle : entre 44.6°F (+7ºC) et 98.6°F
(+37ºC)
Protection : système de chauffage à contrôle
PTC de la température
Conformité norme de sécurité : conforme à UL 1026
ifusc205USAbk.p65 16/05/2001, 11:5810