7
• To remove lever from lid cover, take a screwdriver
and bend carefully the two lips/ribs in the lid
cover outwards and push the lever with force out
of the hinge.
• To reassemble, follow steps backwards, without
using a screwdriver.
To remove the brew chamber head assy, follow
below steps:
• Remove the back cover.
• Place the appliance in front of you in such a way
that you are facing the rear side of the appliance.
• First remove the boiler from the snap lock
position of the brew chamber.
• To remove the brew
chamber, use your both
thumbs (see picture 3)
and push strongly with a
little distortion (rotation)
until the brew chamber
comes loose (upwards).
• Reassemble follow above steps backwards.
To reach the components placed inside the base
(for example exchange the NTC temperature
sensor) follow below steps:
• First remove back cover, three-way valve and
boiler.
• The brew chamber can be removed by
unhooking the two snap locks behind the boiler,
pull the brew chamber upwards to remove it
from the housing.
• Remove both Torx T15 screws B (see exploded
view).
• Unhook the two snap locks on the back side
of the base with a screwdriver (see base), the
housing can now be removed.
• To remove the rest of the housing unlock the last
4 snap locks on the base and gently pull of the
front cover.
• To reassemble follow above steps backwards.
picture 3
Disassembly- and Reassembly advice
To Next Page
Loading...
