English
What’s in the box (Fig. A)
1) Headphones 2) Transmitter
3) AC/DC adaptor 4) Antenna tube
5) 2 x AAA rechargeable shortened sleeve NiMH
batteries (SBC HB700L)
Get started
Note
•
Before using the headphones for the rst time, charge the
supplied batteries for at least 12 hours.
•
Only use Philips rechargeable shortened sleeve
NiMH batteries with your headphones. Other types
of rechargeable batteries cannot be charged with
this system.
•
AAA alkaline batteries can be used to operate
the headphones, but cannot be charged with this
system.
•
If the volume of the audio source is insucient, the
transmitter automatically turns o.
1 Install/Replace supplied batteries (Fig. B).
2 Install the antenna tube into the transmitter (Fig. C).
3 Power on the transmitter (Fig. D).
»
Red LED is on when audio source is connected.
»
Red LED blinks if no audio source is connected for
two minutes.
»
Red LED is o if no audio source is connected for
four minutes.
4 To charge the headphones, connect the charging cable
with the headphones (Fig. E).
»
Headphones: red LED is o during charge.
»
Transmitter: green LED is on during charge and is o
when headphones are fully charged.
5 Power on the headphones and red LED is on (Fig. F).
6 Connect the audio device with the transmitter (Fig. G).
»
Red LED is on when audio source is connected.
Tip
If there is interference, tune the transmitter and the
headphones to the same channel (Fig. H).
Product version table
Version / Region /10 Europe /05 UK
Input voltage / frequency 100-240V / 50/60Hz
Output voltage 8V 200mA
Carrier / Reception
frequency
Channel 1 863.5MHz
Channel 2 864.5MHz
Transmission power <8 dBm
For further product support, please visit
www.philips.com/support
To Next Page
Loading...
