Philips SpeedPro Aqua - Operating Time; Ordering Accessories; Removing the Rechargeable Battery; Recycling

Note: Always store the water tank with the cap removed from the filling hole.
Ordering accessories
To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips
dealer. You can also contact the Philips Consumer Care Center in your country (see the international
warranty leaflet for contact details).
Warranty and support
If you need information or support, please visit www.philips.com/support or read the international
warranty leaflet.
Recycling
-
Do not throw away the product with the normal household waste at the end of its life, but hand it
in at an official collection point for recycling. By doing this, you help to preserve the environment.
-
This product contains a built-in rechargeable battery which shall not be disposed of with normal
household waste. Please take your product to an official collection point or a Philips service center
to have a professional remove the rechargeable battery.
-
Follow your country’s rules for the separate collection of electrical and electronic products and
rechargeable batteries. Correct disposal helps prevent negative consequences for the environment
and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when you discard the product. Before you remove
the battery, make sure that the product is disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when you handle tools to open the product and
when you dispose of the rechargeable battery.
1 Disconnect the appliance from the wall socket and let it run until the motor stops.
2 Remove the dust container from the appliance.
3 Pull the display cover from the top of the handgrip (Fig. 4).
4 Undo the screw of the handle cover and pull the handle cover off the appliance (Fig. 5).
5 Undo the bottom cover screw (1) and then remove the side panels. (Fig. 6)
6 Remove the bottom cover screws on the left and right side (1). Then remove the bottom cover (2)
(Fig. 7).
7 Disconnect the battery connector and the display connector from the printed circuit board (Fig. 8).
8 Undo the battery frame screws (Fig. 9).
9 Remove the battery from the appliance and dispose of it according to the rules (Fig. 10).
Operating time
Using the appliance with Turbo power mode
(Setting 2)
28 minutes*
9
English