8 EN
3
Point at your device with the universal remote. Then press and release
to start searching the code for your brand. A different infrared signal is
sent every 2 seconds as the universal remote searches, indicated by a
blu
e ash.
4
When the device is off, immediately press and release OK to save the
code. The blue LED indicator will turn off.
5
Operate the device with the universal remote. If your device responds
correctly, it means you have saved the right code.
Note
•
Auto registration can be reversed, by pressing and releasing once more during the auto
registration process. This is helpful if you missed out the chance to press OK within 2 seconds.
Make sure that the device is rst powered on again.
• Repeat the same procedures to set up other devices.
max. 20
minutes
To Next Page
Loading...
