Philips SRP9263C/27 User Manual

9
Programming your remote
Did the device turn o?
• If YES, you have found a code for
the device. Press and release the
same device button you pressed
in Step 3. This will store the code
in the remote. Go to Step 7.
• If NO, continue to press and
release the VOL button until
the device turns o to test the
other 9 codes from Step 4. Be sure
to wait approximately 3 seconds
after each VOL button press to
allow the device time to respond
to the code. When the device
turns o, you have found a code
for your device. Press and release
the same device button pressed in
Step 3. This will store the code in
the remote. Go to Step 7.
NOTE:
• The VOL button can be used to
go backwards through each batch
of 10 codes.
• The red indicator light will ash 2
times after testing the rst or last
code in each batch of 10.
7. Use the remote to turn the device
back on. Test the buttons on the
remote to see if the device responds
as you would expect. If the buttons
do not operate the device, return
to Step 2 and repeat this process to
search for a better code to operate
the device.
8. Repeat this process for each device you wish
to control.
Controlling combo devices
Some combo devices (e.g., TV/VCR, TV/DVD, DVD/
VCR, etc.) will require you to set up two dierent
device buttons to control both parts of the combo
device. For example, if you have a TV/DVD combo,
you may need to set up one code under the TV
button to control the TV and a separate code
under the DVD button to control the DVD.
VOL
VOL
SRP4229B_07 ENG Manual v2.indd 9SRP4229B_07 ENG Manual v2.indd 9 9/2/21 5:03 PM9/2/21 5:03 PM

Philips SRP9263C/27 Specifications

General

Brand	Philips
Model	SRP9263C/27
Category	Remote Control
Language	English