Philips SRU 1010 User Manual

Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control can automatically search for the
right code.
1 Make sure the TV is switched on and select a channel using the original remote control or the keys on
the TV (for example channel 1).
2 Keep keys s and y on the SRU 1010 pressed simultaneously for
five seconds, until the indicator light remains lit.
3 Press the y key of the SRU 1010 and keep it pressed.
– The SRU 1010 now starts emitting all known ‘TV off’ signals, one by one.
Each time a code is sent, the indicator light flashes.
4 When your TV switches off (stand-by), immediately release the y key of the
SRU 1010 to confirm.
– The SRU 1010 has now found a code that works on your TV.
5 Check if you can operate all functions on your TV with the SRU 1010.
• If this is not the case, you can redo the automatic setting.
The SRU 1010 will then search for a code that perhaps works better.
– After the SRU 1010 has run through all the known codes, the search will stop automatically and the
indicator light stops flashing.
– Automatic programming of a TV takes a maximum of 6 minutes.
6 ENGLISH

Philips SRU 1010 Specifications

General

Brand	Philips
Model	SRU 1010
Category	Remote Control
Language	English