Philips Trilogy 100 - Page 5

Exit
Settings And Alarms
Options
Alarm log
Select
Navigate
Exit
Settings And Alarms
Options
Alarm log
Event log
Information
M
enu
1
/10
Select
Navigate
Cancel
Dual Prescription OFF
Circuit Type Active PAP
Mode S/T
Menu Settings and Alarms
2/23
OK
Edit
Finish
AVAPS OFF
IPAP 30.0 cmH20
E
PAP 8.0 cmH20
Modify
Navigate
Finish
Mode S/T
A
VAPS OFF
IPAP 30.0 cmH20
EPAP 8.0 cmH20
Modify
Navigate
Make sure Trilogy100 is turned off before taking the following steps
Select Settings And Alarms
Select Settings And Alarms
Use to choose Active PAP (exhalation
valve set-up) or Passive (exhalation port set-up)
and then press twice to confirm
Press to change the parameter
highlighted in blue
Prescription set-up
4
B
B
D
C
D
Menu
Exit
Dual Prescription OFF
Circuit Type Passive
Mode S/T
M
enu Settings and Alarms
2
/23
Modify
Navigate
A
A
E
C
From main screen, press Menu
Press and hold and for a few seconds
to access Set-up
page
Navigate to CircuitType and press
Dual Prescription
If Dual Prescription is enabled, both prescriptions
need to be adjusted as previously explained
Dual Prescription ON
Mode S/T
AVAPS ON
Tidal Volume 400 ml
IPAP Max Pressure 25.0 cmH20
Menu
Settings And Alarms
1/20
Navigate
Modify
Finish
Two prescriptions to set
Exit
Switch to Secondary Settings
Safely Remove SD Card
Primary Settings and Alarms
Secondary Settings and Alarms
Options
Menu
3/8
Select
Navigate
RR 20BPM
PIP
5.9
cm
H
2
O
Vte
435ml
Leak
21l/min
Peak Flow
67.9l/min
MinVent
8.7l/min
Scroll up and down using to navigate
through the settings and alarms
Press to begin therapy or
continue navigating through the menu
to set-up the ventilation parameters
Cancel
AVAPS ON
Tidal Volume 400 ml
IPAP Max Pressure 25.0 cmH20
OK
Edit
Press to validate new setting
F
Cancel
AVAPS ON
Tidal Volume 400 ml
IPAP Max Pressure 25.0 cmH20
OK
Edit
Mode S/T
AVAPS ON
Tidal Volume 400 ml
IPAP Max Pressure 25.0 cmH20
Navigate
Modify
Finish
E
G
Use to change the value or status
of setting
Press and
to return to the main screen
Set-up screen
3
Press to enter Menu Access
Navigate to Options and press
To enable full access to the settings
Setting the Active or Passive circuit
B
D
Use to choose Full or Limited Access
and press to confirm
A
C
Press and
to return to Initial Screen
Exit
Settings And Alarms
Options
Alarm log
Event log
I
nformation
Select
Navigate
Finish
Menu Access Limited
Detailed View OFF
L
anguage English
M
enu Options
1/18
M
odify
Navigate
Cancel
Menu Access Full
D
etailed View OFF
L
anguage English
M
enu Options
1/18
OK
Edit
Finish
Menu Access Full
Detailed View OFF
Language English
Menu Options
2/18
Modify
Navigate
Setting menu access