Install the Internal Battery
Insert the bottom push it in lock the battery
1. Carefully insert the bottom of the battery into the frame
mount receptacle. Make sure it’s in the right position.
2. Hold the battery and push it into the frame until you hear
the sound of the lock.
3. Turn the key clockwise to lock the battery on the frame.
Then remove the key.
NOTE:
4. When removing the external battery, turn the key counter-
clockwise to open the lock. slide the battery upwards and lift
it off the frame.
5. Do not force the battery into the receptacle. slowly align
and push the battery down into the receptacle.
6. When the battery is removed, be careful not to drop or
damage the battery. Avoid damaging the exposed connector
terminals and keep them clear of debris or water.
7. Ensure the battery has been properly secured to the bike
before each use. Pulling carefully upwards on the battery with
both hands to test the security of the attachment of the
battery to the mount.
8. Before each use, close the battery lock and remove the key.
If the lock does not close or the key cannot be removed, the
battery has not been properly installed.
9. Keep the keys properly.
To Next Page
