Need help?Do you have a question about the Phoenix Contact RAD-2400-IFS and is the answer not in the manual?
General| Frequency | 2.4 GHz |
|---|---|
| Wireless Standard | IEEE 802.15.4 |
| Impedance | 50 Ω |
| Housing Material | Plastic |
| Interface | RS-485 |
| Operating Voltage | 9 - 30 V DC |
| Operating Temperature | -40 °C to +60 °C |
| Encryption | AES |
| Storage Temperature | -40 °C to +85 °C |
Details specifications for various I/O extension modules.
Lists supporting accessories for the wireless system.
Defines approved applications and operating conditions for the wireless system.
Provides essential safety and installation guidelines for proper device setup.
Details specific safety requirements for installing the device in potentially explosive areas.
Specific notes and warnings for various I/O extension modules.
Overview of the wireless module's features and capabilities.
Details the types and features of available I/O extension modules.
Identifies the components and connections of the wireless module.
Illustrates the fundamental electrical connections and components of the wireless module.
Instructions on how to physically install and remove the wireless module and I/O extensions.
Steps for properly connecting electrical wires to the device terminals.
Details how to connect the power source to the wireless module.
Information on configuring and using the RS-232 and RS-485 serial communication interfaces.
Guidance on how to connect the external antenna to the wireless module.
Factory default parameters for the wireless module.
Explains different operational modes for signal and data transmission.
Setting wireless module and I/O module addresses via thumbwheel.
Using CONFSTICK, memory stick, and PSI-CONF software for setup.
Overview of status LEDs and bar graphs for module diagnostics.
Procedures for integrating and configuring I/O extension modules.
Information on the time required for the wireless station to become operational.
Explains data frame structure and timing parameters for serial communication.
Steps for configuring the system for PLC/Modbus RTU communication using software.
How to assign I/O-MAP addresses to extension modules in PLC/Modbus RTU mode.
Explanation of the watchdog function for monitoring Modbus connection reliability.
Lists and describes the Modbus function codes supported by the system.
Overview of the Modbus/RTU communication protocol and its master/slave operation.
Practical examples demonstrating Modbus register read/write operations.
How to read module types and error codes from registers.
Overview of Phoenix Contact's proprietary wireless technology and its features.
Guidance on planning wireless connections, considering height and obstacles.
Steps for conducting on-site tests to verify wireless system performance.
Criteria and guidelines for choosing and properly installing antennas.
Factors affecting signal propagation like path loss, Fresnel zone, and interference.
Guideline ranges and example calculations for wireless system performance.
Real-world examples illustrating signal attenuation due to environmental obstacles.
Procedure for performing a loopback test to verify RS-232 serial data path functionality.
To Next Page