Phoenix 301 User Manual

Connecting the Quattro3 (301)
COMPUTER:
This connection is for any session using your computer, such as Voice Over IP applications
(Skype, Microsoft Lync, etc.).
Using the USB cable provided, plug the mini USB side of the cable into the Q3 (located on the
connector panel below the unit). Then plug the USB end of the cable into any USB port on your
computer.
Your Quattro3 is ready to use. No additional drivers or steps are needed; however we do
recommend downloading and using our “Phoenix Audio Setup Utility” for optimal audio control
and performance. This utility can be found on our website www.phnxaudio.com
.
For more connection options, you can purchase different modules separately to add on to your
Quattro3. Below is a list of the different interface modules that can be installed in your Quattro3:
Model Connection
302 Telephone
303
Analog Audio, Smart Phones
/ Tablets
304 Daisy Chain Power Kit
305 SIP / IP Phone
NOTE:more information regarding the different interfaces can be found on our website.

Phoenix 301 Specifications

General

Brand	Phoenix
Model	301
Category	Telephone
Language	English