To Next PageTo Next PageWhat to do if Phoenix PWB-1530 Automobile Accessories machine does not turn on?
If your Phoenix Automobile Accessories machine isn't turning on, begin by inspecting the on/off switch. Then, check all wire connections and trace the electrical current to identify any errors in the electrical wiring.
Why is the measurement result beyond the range in Phoenix Automobile Accessories?
The measurement result is out of range because you either tried to calibrate the Phoenix Automobile Accessories machine without adding wheel weights, or you placed a wheel that's too light or too heavy for the machine.
What to do if rotating speed is too low for Phoenix Automobile Accessories?
If the rotating speed of your Phoenix Automobile Accessories machine is too low, try the following: 1. Tighten the drive belt. 2. Ensure the spin shaft is tight and spinning correctly. 3. Verify the motor is functioning as it should. 4. Use a heavier wheel. Note that this machine is designed for balancing full-size car and truck tires, not smaller tires like those on ATVs.
Why Phoenix Automobile Accessories machine seems to overheat and shut down automatically?
If your Phoenix Automobile Accessories machine is overheating and shutting down, check the transformer temperature when it shuts down. If it's extremely hot, the transformer needs replacement. If the transformer isn't hot, the power board likely needs to be replaced.
Why does Phoenix PWB-1530 Automobile Accessories machine trip electrical breaker?
If your Phoenix Automobile Accessories machine trips the electrical breaker, the transformer or power board are likely defective and need to be replaced.
What to do if guard was not closed when spinning wheel on Phoenix PWB-1530 Automobile Accessories?
If the guard was not closed when attempting to spin a wheel or the guard was raised while the wheel is spinning on your Phoenix Automobile Accessories machine, you can use the system settings to turn guard control to OFF. However, avoid raising or lowering the guard while the wheel is spinning.
What to do if the rotation is in the wrong direction in Phoenix PWB-1530 Automobile Accessories?
If the rotation is in the wrong direction on your Phoenix Automobile Accessories machine, and you are using a 3-phase motor, adjust the three-phase wires.
General| Brand | Phoenix |
|---|---|
| Model | PWB-1530 |
| Category | Automobile Accessories |
| Language | English |
Operator safety, clothing, eye protection, environmental conditions, and surge protection.
Procedures for unpacking, placement on a stable floor, and connecting the wheel balancer.
Details display windows, indicator points, and labeled sections of the control panel.
Explains the function of each key/button on the control panel for operation.
How to enter system settings mode and use UP/DOWN keys to navigate selections.
Configuration options for standardization, buzzer, units, and width/diameter input.
Guidance on measuring wheel parameters for input into the machine.
Explains the necessity and process for entering wheel parameters before calibration or balancing.
How to measure and enter the distance parameter (A) for wheel balancing.
How to input the width (B) and rim size (D) parameters for balancing.
Step-by-step instructions to calibrate the wheel balancer before use.
Details subsequent calibration steps and how to verify successful completion.
Instructions for balancing steel wheels using clip-on weights on both sides.
Demonstrates the steps for zeroing out balance for inside and outside of the rim.
How to perform static balancing by placing weights only on the outside of the rim.
Guidance for balancing rims that do not accept clip-on weights on one or both sides.
Detailed instructions for accurate stick-on weight placement in ALUS mode.
Lists error codes, their meanings, and suggested solutions for machine issues.
Refers to tire manufacturer instructions for matching tires to the correct rim.
How to balance motorcycle wheels, requiring a special adapter.
Addresses errors like incorrect rotation, calibration failures, and weight sensor issues.
Solutions for issues like tripping electrical breakers, overheating, and the machine not turning on.
Explains the different aluminum modes (1, 2, 3, S) and weight placement.
Guides on measuring parameters A-1, A-E, D-1, D-E for aluminum wheels.
