What to do if the volume of my multimedia device is too low on my Phonak Hearing Aid?
If the volume of your multimedia device is too low, the volume settings may be incorrect. Increase the volume of the audio source.
What to do if my Phonak Roger Table Mic remote control is not responding?
If the remote control for your Phonak Hearing Aid isn't responding, the battery may be empty or have a low charge. Replace the battery with a new one (type CR2032). Also, charge Roger Table Mic as soon as possible.
Why does my Phonak Hearing Aid keep losing the audio signal?
Your Phonak Hearing Aid might be losing the audio signal due to a software issue. Reboot Roger Table Mic by simultaneously pressing the on/off and Connect button. Also, the distance between Roger Table Mic and Roger receiver may be too large, or there might be obstacles. Try moving closer to Roger Table Mic and make sure there's a clear line of sight between you and Roger Table Mic.
What to do if my Phonak Hearing Aid Roger Table Mic has stopped working?
If your Roger Table Mic has stopped working, it might be due to a software issue. To resolve this, reboot Roger Table Mic by simultaneously pressing the on/off and Connect button.
Why I cannot hear my multimedia device using my Phonak Hearing Aid?
If you cannot hear your multimedia device, it could be due to several reasons: the audio source might be muted, Roger Table Mic might be muted, or Roger Table Mic might be using the audio cable but is not switched on. Unmute the audio source, unmute Roger Table Mic, and switch on Roger Table Mic to listen to the audio source via the audio cable.
How to connect my Phonak Hearing Aid Roger Table Mic with another Roger microphone due to software incompatibility?
If you are unable to connect your Roger Table Mic with another Roger microphone due to software incompatibility, upgrade all your Roger microphones using the Roger Upgrader available on the Phonak website or contact your local Phonak dealer.
Why is my Phonak Hearing Aid Roger Table Mic blinking blue?
If Roger Table Mic is switched on but its light is blinking blue, Roger Table Mic was part of a network. Press the connect button on Table Mic.
General| Type | Microphone |
|---|---|
| Technology | Roger technology |
| Microphone Type | Omnidirectional |
| Charging Time | 3 hours |
| Compatibility | Compatible with Roger receivers and hearing aids |
| Connectivity | Wireless |
| Charging | USB |
| Operating Modes | Automatic, Manual |
| Operating Range | Up to 20 meters |
To Next Page
