©David Crowhen and Winner Tian - Phonak New Zealand
Phonak RogerDirect Uninstall Guide: Roger X + Installer Pad
1. (Ensure hearing aid is switched off) Plug the
Roger X into the Europlug on the side of the
installation pad
6. A solid green light next to the Roger X receiver
indicates successful transfer of the RogerDirect
receiver code back into the Roger X receiver – the
hearing aid no longer contain the RogerDirect
receiver code
2. Switch on the Roger installer
7. Remove hearing aid from the Roger installer pad
3. No light next to the Roger X receiver indicates the
Roger X is empty i.e., has no RogerDirect receiver
codes in it
8. Switch off the Roger installer pad
4. Turn the hearing aid on and place the hearing aid
on the hearing aid outline on top of the Roger
Installer pad
10. The Roger X now has the RogerDirect receiver
code back in it and is awaiting installation into
the next hearing aid.
5. The light next to the hearing aid will begin
blinking green indicating the un-installation is in
process
Important: It is recommended to keep a minimum
of 3m between each Roger Installer during
installation/uninstallation and to keep all other
hearing aids and Roger devices near the installer
pad turned off.
See reverse for the installation guide
To Previous Page
Loading...
Need help?
General
