Phonemo P3200 - Page 4

L 09. Instruction for replacing cutter holder
If the !abe؛ tape cannot be cut neatiy after contjnuous
use, piease replace the
cutter holder as shown In the following diagram.
L 10. Troubleshooting ل
Problem
Solution
Unable to start the label
maker
Check if the label maker has sufficient power
1. Check ¡fthe label tape Is installed correctly
2. Check If the label tape compartment cove؛ ¡S closed
3. Check Ifthe label tape is exhausted
Cannot print or the texts
are not displayed correctly
The print head may be dusty. Take out the label
tape, gently wipe the print head vertically with a dty
'cotton swab
Warning: Please do not touch the print head with
your hand to avoid getting burned
There Is a white horizontal
line In printed labels
Check If Bluetooth Is enabled on your phone and
make sure the phone has connected label maker
through theApp
Unable to print using my
phone
L 11. Warranty و
Thankyou for choosing our label maker.
Φ Our warranty provides "Exchange/Return" services
within one year of
purchase.
® Please keep the warranty card In a safe location for future reference.
If you have any problem or need on our product or this
user manual, please
feel free to contact ourcustomer se^lces. We will do
our best to help you.
12. FCC Caution
This device complies with part IS of the FCC Rules.
Operation is subject to the
following two conditions:
(l)Thls device may not cause harmful interference, and (2) this device must
accept any interference received, including Interference
that may cause unde-
sired operation.
Any Changes or modifications not expressly approved
by the party responsible
for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed andused in accordance with the instruc-
tions, may cause tiarmful interference to radio communications. However,
tliere is no guarantee that interference will not occur
in a particular Installa-
tion. Ifthis equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user isenCouraged to try to correct the interference by one or more oi the
following measures:
-Reorient or relocate the receiving antenna.
-Increase tire separation between"the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure
requirement.
The device can be used in portable exposure condition without restriction.
Вфрп
01.
l'jyÿ-
A
iil
□