PHOTON REVOX SPX-TA07

Questions and Answers

G
Gregory HendersonAug 7, 2025
What to do if I see a 'PWR CAP ERROR' on my PHOTON Power Supply?
- T
  thompsondavidAug 7, 2025
  If you see a 'PWR CAP ERROR' on your PHOTON Power Supply, it means the power supply capacity isn't sufficient for the SPX-TA length. To resolve this, connect a suitable type of the CB-T and restart it.
D
davisbrittanyAug 13, 2025
What to do if I get a 'PWR ERROR' on my PHOTON Power Supply?
- E
  Emily HamptonAug 13, 2025
  If you encounter a 'PWR ERROR' with your PHOTON Power Supply, turn the power off and then restart the CB-T to resolve the issue.
L
lorraine54Aug 19, 2025
What to do if I see 'LED TEMP ERROR' on PHOTON Power Supply?
- M
  Michael NicholsSep 12, 2025
  If you're getting an 'LED TEMP ERROR' on your PHOTON Power Supply, wait for a while. The CB-T will go into standby when the LED temperature decreases enough. Then, turn the LED on again.
J
joseph31Aug 25, 2025
What to do if I see 'AddSet ERROR' on my PHOTON Power Supply?
- J
  James Scott MDAug 26, 2025
  In case of an 'AddSet ERROR' on your PHOTON Power Supply, make sure the cable is securely fastened, and then restart the CB-T.
G
Gregory BrownAug 30, 2025
How to fix 'LED OPEN ERROR!! ADDRESS #12' on PHOTON Power Supply?
- W
  Wyatt CookAug 31, 2025
  To address the 'LED OPEN ERROR!! ADDRESS #12' on your PHOTON Power Supply, turn the power off and restart the CB-T.

Summary

Safety Precautions

Installation Safety Guidelines

Guidelines to prevent hazards during product installation.

Product Outline

Part Names and Functions

Connecting the Devices

Power Control

Power ON;OFF Operation

Steps to turn the CB-T power supply unit on and off.

LED Light ON;OFF Control

Instructions for controlling the LED light using panel or external modes.

Illuminance Control Mode Selection

Control Mode Selection Process

Step-by-step guide to selecting the desired illuminance control mode.

Pulse Control Operation

Using Pulse Control

Guide on how to enable and use high-speed pulse control mode.

Illuminance Level Control Methods

Manual Illuminance Adjustment

How to adjust light intensity using the manual control knob.

Analog Signal Illuminance Control

Using 0-5V analog signals from external equipment to control light level.

Digital Signal Illuminance Control

Using 8-bit or 10-bit digital signals to control light intensity.

Communication Control

RS232 C Communication Control

Using RS232C port for controlling illuminance and other functions.

Ethernet Communication Control

Using Ethernet port for controlling illuminance remotely.

Software and System Information

Software Version Check

Procedure to view the CB-T's current software version.

Troubleshooting and Support

Error Message Troubleshooting

Explains common error messages and how to resolve them.

General Troubleshooting Tips

Provides general advice if the product is not working correctly.

Warranty and Repair

Warranty Terms and Conditions

Details the product warranty period, coverage, and limitations.

Repair Service Information

Information and contact details for requesting product repair services.