and make sure the battery power is strong enough
to power on the flash. If the power of the internal
batteries is not sufficient, the Indra Battery Pack
cannot power the ash.
Picture 10
2. Make sure all the power cords are well connected
to the Battery Pack. When the output toggle switch is
turned on, the Battery level indicators will light green.
If no device has been detected, both output ports will
cut o automatically after 10 seconds, and the Battery
indicators will go out. If a device has been detected by
either of the output port, the corresponding output
will start powering, and the corresponding Output
indicator (orange) and the Battery level indicators will
light up simultaneously. (See picture 11)
Picture 11
Note: If the output toggle switch is not turned on,
there will be no output from both output ports.
However, there will be output from the USB output
port if a device has been connected to it.
To Next Page
Loading...