Setting and Adjust Ratio Modes
TTL Mode
1. After entering OP Tx (Master) mode (above) press the button to edit
the OP Tx (Master) parameters.
2. Press the
button to select the TTL mode.
3. Pressing the
button, the EV compensation option will be highlighted
and flash on the LCD.
4. Press the
and
buttons will adjust the EV compensation
value (from +3 to -3 in 1/3rd stops).
5. Press the
button to enter parameter setting screen.
6. Press the
and buttons to cycle between Channel and Ratio
Mode.
7. Press the
and to adjust the parameters. (Channel: 1, 2, 3, 4;
Ratio Modes: M: A and M: A: B).
8. Press the
button to confirm and exit.
TTL Mode
1. After entering OP Tx (Master) mode (above) press the
button to edit
the OP Tx (Master) parameters.
2. Press the
button to highlight the ratio area.
3. Select the Ratio mode. Pressing the
and
buttons will cycle
between M:A and M:A:B modes.
4. When M:A or M:A:B is highlighted pressing the
button will highlight
the ratio adjustment selection below the ratio.
5. Press the
and
buttons to adjust the parameters. (Channel:
1, 2, 3, 4; Ratio Modes: M: A and M: A :B; Ratio: each group can be set between-
“-“ (OFF), 1, 2, 4, 8, 16).
6. Press the
button to confirm and exit.
Please note:
The Mitros+ Flash in TTL can show EV compensation setting options and
make EV compensation adjustment only with SLT-A99V/ SLT-A99 and SLT-A58
cameras (as new cameras are released this list may increase). The Mitros+ can-
not show EV compensation setting options or make EV compensation adjust-
ments when used with other cameras. The EV settings are invalid.
Manual Mode
1. After entering OP Tx (Master) mode (above) press the button to
change the flash into Manual (M) Mode.
2. Press the
button to edit the OP Tx (Master) parameters and to
highlight the ratio area.
3. Pressing the
and buttons will cycle between M:A and
M: A:B modes.
4. Press the
button to confirm and exit the screen.
5. Press the
button to adjust power levels.
6. Pressing the
or buttons will change the Flash Power Level
(1/1 to 1/128 in 1/3rd stops).
7. Press the
button to exit power level adjustment mode.
To Next Page
Loading...
