Fightstick PRO Install:
For the Mad Catz Fightstick PRO style of arcade stick, a few extra steps must be taken. Overall the
install is identical; the mounting is just slightly different since there’s very little room.
Step 1. Open the stick and remove the original PCB from its mounting (still marking the cables and
such while doing so as described in the normal install).
Step 2. Break/cut/dremel the 4 plastic standoffs that the board was originally mounted to. Simply
breaking them is just fine, it doesn’t take much effort but a pair of diagonal cutters to cut the 4 spokes,
then wiggling the standoff to break it off is the easiest method.
To Next Page
Loading...