Need help?Do you have a question about the PHREAK MODS Cerberus and is the answer not in the manual?
General| Brand | PHREAK MODS |
|---|---|
| Model | Cerberus |
| Category | Controller |
| Language | English |
Lists the essential tools needed for the Cerberus board installation process.
Suggests additional tools that can be helpful during the Cerberus board installation.
Details on marking and preparing the ribbon cables from the original PCB for connection.
Instructions to check and straighten pins within the ribbon cable headers on the Cerberus board.
Guidance on measuring approximately 6 inches of the USB cable for cutting.
Procedure for cutting the USB cable sheath to expose wires for terminal insertion.
Instructions for opening and inserting USB wires into the Cerberus board terminals.
Ensuring USB wires are correctly seated in terminals based on color markings.
Process for aligning and securely seating the Cerberus PCB into its position.
Reconnecting ribbon cables and optionally securing the USB cable with zip ties.
Opening the stick and marking cables, similar to the normal install.
Instructions to break or cut the four plastic standoffs for board mounting.
Securing the original PCB using adhesive anchors and zip ties.
Mandatory removal of the bottom right corner screw of the JLF mounting plate.
Plugging the stick into a PC and verifying its recognition and button functionality.
Testing the stick in Xbox 360 controller mode with player indicator.
Entering and verifying Bootloader mode by checking LED cycling.
To Next Page