Step 2. Unplug the USB cable, then hold 1P (X) and plug it back in, you should see the 360 guide
ring give a player indicator and show up in the controller applet also. Note that in order to complete
this step you MUST have the Xbox 360 controller drivers installed to your system.
Step 3. Unplug your stick again, and plug it back in with START held down. You will be in Bootloader
mode as is indicated by a cycling guide ring. You will NOT see anything pop up in the game
controllers applet, but you will hear the enumeration sound. Verify the LEDs are cycling in a clockwise
fashion, then unplug your stick a final time.
That’s it! You’re done! It takes longer to read all of this and verify steps than it
does to install the board. If you do it a second time you can probably get it
installed in 15 minutes or less.
To Previous Page
Loading...