76
Operating Instructions
Wait at least 30 minutes after eating, exercising
or bathing before taking a temperature reading.
1- Make sure that the optical lens is clean. (see p.4.)
2- Press the On/Off button to turn the power on. The display
will show all screen icons and will emit a beep. When the
symbol « » appears, the thermometer is ready.
3- To change the reading mode, press the function switch
button and hold it for 3 seconds. The « » symbol
indicates that the thermometer is now in forehead mode.
To switch back to ear mode, press the function switch
button again and hold it for 3 seconds (the « »
will disappear).
To use in forehead mode
1- Ensure that forehead mode
is active (« »).
2- Place the probe at temple level leaving
1 cm between the probe and the skin.
3- Press the scan button. A beep will indicate that the
measurement is complete and that the result will appear
on the display.
Since forehead temperature is lower than ear temperature
and it is easily influenced by ambient temperature, we
recommend to also measure the ear temperature if the
forehead reading is higher than 37°C.
!
!
To use in ear mode
1- Ensure that ear mode is active (“ ”).
2- Gently pull on the top of the ear to
straighten the ear canal. This will give
the thermometer a clear path to the eardrum.
3- Press the scan button. Keep the thermometer still until a
beep is heard.
4- After the beep, remove the thermometer carefully from the
ear canal. The temperature value will appear on the display.
Fever alarm
• When the temperature detected is above
38°C (100.4°F), the backlit screen turns
orange to indicate a possible fever. When
the reading is below 38°C (100.4°F), the
screen will remain green.
36.8
o
C
Correct
34.6
o
C
Incorrect
Eardrum
No fever
Fever
To Next Page
