Manual P3010 Page 3/8
Warning!
•
Ensure that the compressed
air line is properly secured
to avoid personal injury,
equipment damage and/or
application failure.
•
When the product is used
for sensing pressure in
processes handling hazardous
substances and/or gases,
ensure that any leakage is
contained and properly taken
care of.
Wear eye protection
1.2.1 Assembly
Compressed air may be dangerous if used
by unskilled personnel. Assembling, using
and maintaining the product should solely
be carried out by experienced and specially
trained personnel.
Prior to assembly and disassembly of the
components, cut off voltage and pressure.
Install and maintain the components only
after thoroughly reading and understanding
this manual.
1.2.2 Maintenance
Maintenance must be carried out in
accordance with the instructions in this
manual. Prior to any maintenance work,
suspend pneumatic/electrical supply, and
discharge residual pressure.
2. Introduction to
P3010
2.1 Manufacturer
Piab AB
P.O. Box 146
SE-18212 DANDERYD
SWEDEN
2.1.1 Identification label
Each unit is identified by a label with
identification information. For any
communication with Piab AB or service
centers always refer to the label information.
2.2 Product overview
To Next Page
Loading...