PIAB P3010 - Compliance and Intended Use; Product Compliance Declarations; Intended Use Cases; Misuse Warnings

Manual P3010 Page 6/8
2.5 Compliance
Configuration
Item no. Object of declaration
P3010.0X.AX.XX.AB.XX P3010 Config – Valve DS23
P3010.0X.AX.XX.AA.05 P3010 Config – Vacuum switch adjustable PNP NO LM8
P3010.0X.AX.XX.AA.09 P3010 Config – Vacuum switch adjustable PNP NO DM8
P3010.0X.AX.XX.AA.10 P3010 Config – Vacuum switch adjustable NPN NO DM8
P3010.0X.AX.XX.AA.11 P3010 Config – Vacuum switch inductive, adj.
P3010.0X.AX.XX.AA.18/19/20 P3010 Config - VS4015
P3010.0X.AX.XX.AA.21/22/23 P3010 Config - VS4016
P3010.0X.AX.XX.AC.21/22/23 P3010 Config - VS4016
P3010.0X.AX.XX.AD.21/22/23 P3010 Config - VS4016
P3010 AVM2 P3010 AVM™2 configurable Vacuum Ejector
P3010 CU P3010 CU configurable Vacuum Ejector c
are in conformity with the following
European directives:
•
Electromagnetic Compatibility (EMC)
Directive 2014/30/EU
- EN/(IEC) 61000-6-2:2005
- EN/(IEC) 61000-6-4:2007+A1
•
RoHS2 Directive (2011/65/EU)
and the UK legislations:
•
Electromagnetic Compatibility
Regulations 2016
- BS EN/(IEC) 61000-6-2:2005
- BS EN/(IEC) 61000-6-4:2007+A1
•
The Restriction of the Use of Certain
Hazardous Substances in Electrical and
Electronic Equipment Regulations 2012
2.6 Intended use
•
The product is used for creating
vacuum or blow.
•
The product is used to sense pressure
in processes handling hazardous
substances and/or gases.
2.7 Misuse
•
Do not pressurize the product outside
of specification.
•
Do not install or use the product if it is
damaged.
•
Do not use compressed air pressure
or electrical voltage outside the
specification (operation voltage +/- 10%).
•
Do not use the product outside of Low
Voltage Directive (LVD).
•
Do not use the equipment as a stand-
alone unit to fulfill international lifting
standards.
•
Do not use the product for evacuating
liquids.
•
Do not use the product for evacuating
solid content without the use of filter.
•
Do not keep the valves open when
the product is not in operation for
a prolonged time. The seals and
lubrication will degrade.
•
Do not install the product in a
fully closed compartment, without
ventilation and exhaust channeling.
•
Do not use the product if the exhaust
is restricted or blocked.
•
Do not use the product if vacuum and
exhaust port are simultaneously blocked
when unit is generating vacuum.
•
Do not use blow-off functions or
ejector exhaust for pressurizing
components such as cylinders and/or
tank-volumes.
•
Do not use the product if the compressed
air line is not properly secured.