Pickle-ball Kollectaball K-Max User Manual

Instructions for Collecting Pickleballs
Thank you for purchasing a Kollectaball! Our collectors work brilliantly with
Pickleballs however, it’s very important that they are assembled in a slightly
different manner to when collecting tennis balls.
The only difference is in the assembly of the wires; because Pickleballs are
lighter than most sports balls, it’s important you only assemble the cage with
half the wires. This will decrease the tension between the wires and allow the
Pickleballs to enter into the cage instead of being pushed further away when
collecting.
Please insert a wire in every other slot, as seen in the below pictures and
instructions. You will be left with 30 spare wires.
Step 1: Assemble
the handle as
explained in the
instructions that
come in the box.
Step 2: Insert a
wire in every other
slot. (Insert one
wire, miss a space
and then insert the
other).
Step 3: Continue
this until you have
completed the
sequence for the
first black plastic
disk.

Pickle-ball Kollectaball K-Max Specifications

General

Brand	Pickle-ball
Model	Kollectaball K-Max
Category	Sports & Outdoors
Language	English

Summary

Instructions for Collecting Pickleballs

Assemble Handle

Assemble the handle as explained in the box's instructions.

Wire Insertion Pattern

Insert a wire in every other slot, missing one space between wires.

Complete First Disk Assembly

Continue the wire insertion sequence for the first black plastic disk.

Kollectaball Assembly Steps

Wire Correction Tool

Use the wire removal tool to correct mistakes by pulling out wires.

Complete Second Disk Assembly

Place wires into the second black plastic disk, following the same pattern.

Attach Orange Cone

Attach the orange cone to the screw and tighten with the provided spanner.

Handle and Bale Assembly

Handle Assembly Steps

Lay out parts and assemble the handle using screws, washers, and nuts.

Secure Handle Assembly

Tighten the M6 nut and flathead screws to secure the handle assembly.

Attach Bale to Handle

Push the bale into the available hole at the end of the handle.

Final Assembly and Usage

Final Assembly Checks

Perform final tightening of nuts and screws for a secure assembly.