52
53
pico c instruction manual
Rinse the Step Filter and lid with clean tap water. Fill
the clean Step Filter with 1 liter of tap water. Place
the empty Bucket in the center of the Step Filter. Put
the lid on the Step Filter and insert the Step Filter
back into the Pico until it clicks.
₃
tap water
₄
Connect the hoses of the Pico by firmly inserting
the OUT hose connector into the IN hose connector.
Press the Control Knob to start the Rinse Cycle. Pico
will clear the drain line into the Bucket in the Step
Filter, then prompt you to empty the reservoir.
unboxing setup
first
rinse
let's
brew
after
brewing
ferment
your beer
dry
hopping
rack &
carbonate
serving
usage &
care
sous vide glossary
To Next Page
Loading...