138
139
pico c instruction manual
1. Pour 14 ounces of
Descaling Liquid into the
Water Reservoir. Fill the
rest of the Water Reservoir
with clean tap water
(approximately 3.5 liters).
2. Connect the hoses of the
Pico by firmly connecting the
OUT hose connector into the
IN hose connector.
3. Insert the Step Filter with
lid into the Pico. Turn Pico on.
Click Utilities and select RUN
DESCALER.
4 . Once the descaling cycle
begins, it will take roughly 30
minutes to complete. When
the Water Reservoir is empty
press the Control Knob to end
the cycle.
5. Once the descaling cycle
finishes, carefully empty all
liquid from the Step Filter.
Fill the Water Reservoir with
3.5 liters of clean tap water.
Insert the Step Filter with
lid back into the Pico until it
clicks into place. Press the
Control Knob to continue.
When the Water Reservoir is
empty (after approximately
30 minutes) press the Control
Knob to end the cycle.
6. Run a Deep Clean on your
Pico by following the Deep
Clean instructions in the
manual.
pico
descale
estimated time:
hands on: minutes
(total time: hour)
recommended occurrence:
Should be performed after every 20 brews if you are
not using distilled or reverse osmosis water in the Water
Reservoir.
you will need:
• 14 oz. Descaling Liquid (Available on
www.picobrew.com/BrewGear)
• 7 liters of clean tap water
step by
step:
unboxing setup
first
rinse
let's
brew
after
brewing
ferment
your beer
dry
hopping
rack &
carbonate
serving
usage &
care
sous vide glossary
To Next Page
Loading...