Picomed Pico4 - User Manual

Questions and Answers

J
Jacqueline GordonAug 13, 2025
Why does my Picomed Pico4 Transmitter have a short range?
- C
  Christopher BowenAug 13, 2025
  If your Picomed Transmitter has a short range or only works when pointed directly at the receiver, the cause may be a low battery. Try connecting the battery charger. Another cause may be the wrong placement of the receiver. Check if the receiver has a position where it can receive IR-signals without disturbance. Finally, an obstacle may be blocking the IR-signal, so check for any obstructions between the transmitter and receiver.
T
Tyler OlsonAug 17, 2025
What to do if my Picomed Transmitter does not respond?
- C
  christopher53Aug 17, 2025
  If your Picomed Transmitter is not responding, it might be due to an empty battery. Connect the battery charger to resolve this.
A
Amber GutierrezAug 20, 2025
What to do if the Picomed Pico4 Transmitter only functions on some keys?
- M
  Michele RobertsonAug 20, 2025
  If your Picomed Transmitter only functions on some keys, it means that the transmitter was not correctly programmed, and was programmed with the wrong codes. Reprogram it.
B
briannalawrenceAug 25, 2025
What to do if Picomed Pico4 does work for a short time on some or all channels?
- K
  Kathleen TannerAug 25, 2025
  If your Picomed Transmitter works for only a short time on some or all channels, the transmitter was not correctly programmed, specifically without continuous IR. Reprogram it, enabling programmed continuous IR.
K
Kayla AdkinsAug 27, 2025
What to do when IR-capture: Picomed Transmitter signal is sent?
- S
  Samantha PetersonAug 27, 2025
  If, during IR-capture, the Picomed Transmitter signal is sent, it is caused by IR-noise from the environment. Avoid IR-signals from bulbs when capturing IR.
D
Donna HortonAug 31, 2025
Why is there trouble when IR-capture on Picomed Pico4 Transmitter?
- K
  Kathryn PetersonAug 31, 2025
  If you are experiencing trouble during IR-capture with your Picomed Transmitter, it may be due to variable strength or direction of transmitted IR. Try different angles and distances (up to 10+ cm may be used) when doing IR-capture.
T
Tammy HaneySep 4, 2025
What to do when IR-capture: Picomed Transmitter exits IR-capture when first IR-signal is sent?
- J
  juliekiddSep 4, 2025
  If your Picomed Transmitter exits IR-capture when the first IR-signal is sent, it is caused by repetitive IR-signals from the transmitter. Avoid pressing and holding the key when IR-capture is done.
D
David WhiteSep 8, 2025
Why is IR-signal not possible to copy on Picomed Pico4 Transmitter?
- A
  Amanda FrankSep 8, 2025
  Some IR-signals are not possible to copy.